adminLatest Cisco CCNA 200-125 dumps pdf training materials and study guides free download from lead4pass. High quality Cisco CCNA 200-125 dumps pdf practice files and dumps vce youtube update free demo. https://www.leads4pass.com/200-125.html dumps exam training resources. Get the best Cisco CCNA 200-125 dumps exam questions and answers, pass Cisco 200-125 exam test easily.
Latest Cisco 200-125 dumps pdf training materials: https://drive.google.com/open?id=0B_7qiYkH83VRSnZDMkVUWDJzLWM
Latest Cisco 210-065 dumps pdf training materials: https://drive.google.com/open?id=0B_7qiYkH83VRODRqVmVBYWxuc0k
Vendor: Cisco
Certifications: CCNA
Exam Name: CCNA Cisco Certified Network Associate CCNA (v3.0)
Exam Code: 200-125
Total Questions: 966 Q&As
QUESTION 1
Which command is necessary to permit SSH or Telnet access to a cisco switch that is otherwise configured for these vty line protocols?
A. transport type all
B. transport output all
C. transport preferred all
D. transport input all
Correct Answer: D
QUESTION 2
Three switches are connected to one another via trunk ports. Assuming the default switch configuration, which switch is elected as the root bridge for the spanning-tree instance of VLAN 1?
A. the switch with the highest MAC address
B. the switch with the lowest MAC address
C. the switch with the highest IP address
D. the switch with the lowest IP address
Correct Answer: B
QUESTION 3
Which three statements about static routing are true? 200-125 dumps (Choose three.)
A. It uses consistent route determination.
B. It is best used for small-scale deployments.
C. Routing is disrupted when links fail.
D. It requires more resources than other routing methods.
E. It is best used for large-scale deployments.
F. Routers can use update messages to reroute when links fail.
Correct Answer: ABC
QUESTION 4
Under normal operations, cisco recommends that you configure switch ports on which vlan?
A. on the default vlan
B. on the management vlan
C. on the native vlan
D. on any vlan except the default vlan
Correct Answer: D
QUESTION 5
Which two statements about late collisions are true? (Choose two.)
A. They may indicate a duplex mismatch.
B. By definition, they occur after the 512th bit of the frame has been transmitted.
C. They indicate received frames that did not pass the FCS match.
D. They are frames that exceed 1518 bytes.
E. They occur when CRC errors and interference occur on the cable.
Correct Answer: AB
QUESTION 6
Refer to the exhibit. 200-125 dumps
Switch port FastEthernet 0/24 on ALSwitch1 will be used to create an IEEE 802.1Q- compliant trunk to another switch. Based on the output shown, what is the reason the trunk does not form, even though the proper cabling has been attached?
A. VLANs have not been created yet.
B. An IP address must be configured for the port.
C. The port is currently configured for access mode.
D. The correct encapsulation type has not been configured.
E. The “no shutdown” command has not been entered for the port.
Correct Answer: C
QUESTION 7
A router has learned three possible routes that could be used to reach a destination network. One route is from EIGRP and has a composite metric of 20514560. Another route is from OSPF with a metric of 782.
The last is from RIPv2 and has a metric of 4. Which route or routes will the router install in the routing table?
A. the OSPF route
B. the EIGRP route
C. the RIPv2 route
D. all three routes
E. the OSPF and RIPv2 routes
Correct Answer: B
QUESTION 8
Which command can you enter to display the operational status of the network ports on a router?
A. show interface switchport
B. show ip interface brief
C. show running-config interface fastethernet 0/1
D. show interface status
Correct Answer: B
QUESTION 9
In which three ways is an IPv6 header simpler than an IPv4 header? 200-125 dumps (Choose three.)
A. Unlike IPv4 headers, IPv6 headers have a fixed length.
B. IPv6 uses an extension header instead of the IPv4 Fragmentation field.
C. IPv6 headers eliminate the IPv4 Checksum field.
D. IPv6 headers use the Fragment Offset field in place of the IPv4 Fragmentation field.
E. IPv6 headers use a smaller Option field size than IPv4 headers.
F. IPv6 headers use a 4-bit TTL field, and IPv4 headers use an 8-bit TTL field.
Correct Answer: ABC
QUESTION 10
What will be the result if the following configuration commands are implemented on a Cisco switch?
Switch(config-if)# switchport port-security
Switch(config-if)# switchport port-security mac-address sticky
A. A dynamically learned MAC address is saved in the startup-configuration file.
B. A dynamically learned MAC address is saved in the running-configuration file.
C. A dynamically learned MAC address is saved in the VLAN database.
D. Statically configured MAC addresses are saved in the startup-configuration file if frames from that address are received.
E. Statically configured MAC addresses are saved in the running-configuration file if frames from that address are received.
Correct Answer: B
Read more: https://www.leads4pass.com/200-125.html dumps exam questions and answers free try.
Watch the video to learn more: https://youtu.be/nF4Ul2viODM